Alarm Lock Trilogy DL2800 Instrukcja Obsługi Pobierz pdf (Strona 6)

Battery Replacement

When a valid code is entered and the batteries are weak the

lock LED will light amber, and the sounder will sound for 4

seconds. The DL2800 uses 5 AA-size 1.5 volt alkaline

batteries. The lock will function with weak batteries; however

be sure to replace the batteries as soon as possible.

Remove the screw at the bottom of the housing and remove

the cover. Remove battery box and replace all 5 batteries

quickly - within 2 minutes.

Note:

Do not press any buttons

while replacing the batteries (unless existing lock

programming is to be erased). Pressing any key will remove

the voltage that is required to keep the system clock and

Audit Trail.

Power-Up - Retain Lock Programming

(Audit Trail and Clock Settings lost)

1. Disconnect the battery box.

2. Press any key to insure the locks capacitor is fully

discharged.

3. Re-connect battery box (lock will give 3 short beeps).

Do not press any keys for 10 seconds

5. After the 10 second period the LED will flash red 6 times

and 6 beeps will sound.

The lock is now ready for use. Program is loaded from

non-volatile memory. Set the clock using functions 38, 39

and 40.

Power-Up - Erase All Programming

(Factory Default will be loaded)

1. Disconnect the battery box.

2. Press any key to insure locks capacitor is fully discharged.

3. Re-connect the battery box (lock will give 3 short beeps).

Press any key within 5 sec after hearing the 3 beeps

5. A series of 12 slow beeps will be heard followed by 20

seconds of silence, followed by 6 fast beeps.

All programming has been erased and the lock is now ready

for use.

Note:

All lock programming can also be erased by entering

Function 99.

Self Diagnostic Indications

Various system tests are performed at power up and during

operation of the lock.

Steady 4 Second Sounder with a Yellow LED indication

every time a user code is entered

- indicates a Low Battery

Condition.

Continuous Series of Beeps

- indicates the lock detected a

system fault which would not allow any part of the system to

operate. Ensure batteries are good.

Sequence of 7 Beeps Repeated 4 Times with a Yellow

LED indication, every time a user code is entered

indicates a non-fatal memory or clock error has been

detected. Under this condition, unexpected operation is

possible. Do not mistake the low battery indication as a

memory or clock error.

Wire Leads for DL2800 Models

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Komentarze do niniejszej Instrukcji

Brak uwag

Alarm Lock Trilogy DL2800 Instrukcja Obsługi Strona 6

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Alarm Lock Trilogy DL2800