Alarm Lock PL6100 Instrukcja Obsługi Pobierz pdf (Strona 9)

Erase All Programming

Restore the "out of box" factory condition.

1. At the back of the lock, remove the lock housing screw and remove the cover.

2. Take out battery pack and remove battery power by disconnecting the battery pack plug.

3. With battery power disconnected, short the two white wires (Remote Input wires) together for 10

seconds to ensure discharge of all capacitors. After 10 seconds, remove the short.

4. Plug in the (provided) male shunt connector into the yellow wire female connector.

5. With shunt connector connected, re-connect the battery pack. The lock will immediately sound 3

short beeps (if these 3 beeps are not heard, then restart at step 3).

6. The lock will then sound more slow beeps, 1 beep for every second it takes to clear the memory.

7. Lock is ready for programming after 2 rapid beeps are heard and 2 green LED flashes are seen.

Verifying Proximity Card and Keyfob Access

Test by simply presenting a valid proximity card or fob to the reader in front of the lock.

VALID CARD - Green LED flashes, the sounder beeps several times and the PL6100 unlocks.

INVALID CARD - Red LED flashes several times and the sounder beeps several times.

Testing the Cards Entered

Use when re-applying power to a lock already in use (you wish to retain the Lock Program), such as when

moving an existing lock to a new door. The lock must be dismantled and powered down for an extended

period.

1. Disconnect battery pack connector.

2. With battery power disconnected, short the two white wires (Remote Input wires) together for 10

seconds to ensure discharge of all capacitors.

3. Re-connect battery pack (lock will sound 3 short beeps). If these 3 beeps are not heard, then restart

at step 1. The lock will perform several self tests; when complete, 7 beeps and LED flashes will

sound. The lock is now ready for use.

Power Up--Retain Existing Programming

ACTIVITY LED SOUNDER COMMENTS

Access Granted or

Remote Release

2 Green Flashes 2 Beeps

Invalid Card 7 Red Flashes 7 Beeps An invalid card does not exist in the Lock Program memory.

Valid but disabled card

1 Green, 4 Red

Flashes

1 Long, 5 Short Beeps A proximity card exists in memory, but is disabled.

Low Battery

Red Flashes for

Four Seconds

4-Second Pulsing Beep

See "Battery Replacement" on page 8.

Emergency Commands

are in effect

1 Red Flash every

two seconds

LED and Sounder Indicators

With a fully charged battery, the LED and sounder provide visual and audible feedback as follows:

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Komentarze do niniejszej Instrukcji

Brak uwag

Alarm Lock PL6100 Instrukcja Obsługi Strona 9

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Alarm Lock PL6100